The HT hopper heating module is a rugged, self-contained high performance heater designed for reliable operation on surfaces prone to vibration. Designed to provide heat outputs up to 3 watts per square inch (4,650 watts per square meter) depending on the application, the HT module distributes heat evenly over the entire panel surface. To ensure optimal performance, each system is engineered by Thermon based on the heating requirements of the application.
A parallel circuit design, based on a stamped high temperature INCONEL® heating element, provides the HT heating module with multiple flow paths for electrical current to pass. This design eliminates the burnout potential common with series wire-based designs. Protection of the heating element from vibration is achieved with a cushion layer of insulation that also directs the flow of heat from the module to the surface being heated.
The rugged construction of the module includes a tough 20- gauge aluminized steel that provides mechanical protection during handling, installation and operation. Weld splatter, rust or oil will not affect the integrity or performance of the heater. The low profile design of the panel permits rapid, troublefree installation with the template and mounting kit available from Thermon.
HT hopper heating modules are approved for use in ordinary (nonclassified) and hazardous (classified) areas.
Supply Voltages: 120 - 600 VAC
Maximum Maintenance Temperature: 800°F
|PRODUCT LITERATURE||INSTALLATION INSTRUCTIONS|